y_p_w
Thread starter
I think I know what the steel fitting is, or at least an equivalent.
The 3/8” flare side was forced into a 1/2” FIP fitting with a lot of RectorSeal 5 at the tip against the valve fitting. The 1/2” MIP side is odd, as there’s also a 3/8” FIP fitting inside. Anyone know what this is meant for?
BrassCraft AU2-6-8S 3/8 in. O.D. Flare x 1/2 in. MIP (3/8 in. FIP) Steel Gas Fitting
AU2-6-8S BRASS CRAFT MALE UNION 3/8 OD X 1/2 MIP X 3/8 FIP
supplyonline.com
The 3/8” flare side was forced into a 1/2” FIP fitting with a lot of RectorSeal 5 at the tip against the valve fitting. The 1/2” MIP side is odd, as there’s also a 3/8” FIP fitting inside. Anyone know what this is meant for?