Engine internal washing

Status
Not open for further replies.
Originally Posted by Superbenz
The job should be done at machine shop, they wash in a tank but the guy told me that I have to clean oil and water ducts again with a solvent.
My question is what kind of solvent to use?

I would think they have the solvent. Are they asking you to buy it?
 
More than anything else, make sure to clean the oil passages with a nylon tube brush, some form of solvent and compressed air.

[Linked Image from images.homedepot-static.com]
 
Last edited:
Hot tank at the machine shop. When home, soap & water with a set of engine cleaning brushes and rags. Immediately blast with compressed air, then follow with WD-40 on the iron parts (liners, for example) to prevent flash corrosion.
 
Originally Posted by bullwinkle
Hot tank is the best way to clean a machined block, followed by careful pressure washing.


Yes, the engine rebuild shop (or machine shop) should have a way to get the block (crankcase) very clean
 
Originally Posted by atikovi
I don't think the term "hot tank" has been used since the 70's. Some of you guys must be ancient.
grin2.gif
There are ultrasonic cleaners and automated parts washers now. https://www.youtube.com/watch?v=VKt8Nz7c40w




I haven't been called ancient yet but I have driven cars with oil bath air filters, no power steering and manual chokes.
 
Originally Posted by PimTac
Originally Posted by atikovi
I don't think the term "hot tank" has been used since the 70's. Some of you guys must be ancient.
grin2.gif
There are ultrasonic cleaners and automated parts washers now. https://www.youtube.com/watch?v=VKt8Nz7c40w




I haven't been called ancient yet but I have driven cars with oil bath air filters, no power steering and manual chokes.


Have to add, hand cranked, to be called ancient.
 
Status
Not open for further replies.
Back
Top