Ball joint boot question

[lastofthebreed_ws6]

Hey guys!

Just installed new loaded arms on my 2002 Trans am. The boots have a “relief” in them but I’ve grease them around equal, no grease is been expelled from the releif but the driver side looks a little different from passenger. Both sides the bolts have a little squish to them with no seepeage. All look ok to you guys here? I don’t want to over grease just want to make sure they are good

Left side almost is like flattened on one side

First two pics are right side front/back
Last two pics are left side front/back

 

[Lubener]

I pump grease in till the boot just begins to swell then stop. If you have given each a couple pumps, you will be fine.

 

[lastofthebreed_ws6]

Thanks. They look plump but when I push them they squish easy with my finger and don’t feel too tight. However I guess since they have that valve I couldn’t really over fill them anyway.