So scrapped my pre wiring and just started wiring in place. Got it all working, syphoned the gas out by using the hose going to the fuel filter but I want to run it empty and them measure the on/off volume as I'm constrained at where it can be mounted. Probably around 1/2 gallon.
Light is on the right hand control lever, sensor will be mounted with double stick tape in the front center lowest I can get it on the tank. I ended up using those small stereo wiring connecters. They work great for sub 20 ga wire. Shoved some 1/4" 14ga male crimp connectors, that I gave a slight twist to the blade, into the back of the starter/power switch connector. It worked great as a tight fit and nearly flush. Got a ground and switched power from that.
Light is on the right hand control lever, sensor will be mounted with double stick tape in the front center lowest I can get it on the tank. I ended up using those small stereo wiring connecters. They work great for sub 20 ga wire. Shoved some 1/4" 14ga male crimp connectors, that I gave a slight twist to the blade, into the back of the starter/power switch connector. It worked great as a tight fit and nearly flush. Got a ground and switched power from that.