Hello everyone! So me and my husband replaced the engine in my 2005 Toyota sequoia. We know for a fact the new engine ran before we took it out of the other truck. After we got the engine put in and everything hooked back up the motor will not even crank to try to start. We even went as far as swapping the ecm from the other truck. We reset the ecm/security sytem and key programming. We have checked all fuses including the battery/ fuseable link. Took all the wire connections off and replugged them in. And Double checked the ground wires. We are completely stumped on what could be going on and im at my wits end with it! Is there anyone on here that has had this issue and found a solution? If anyone has any other ideas on what the heck could going on please, please let me know! TYIA!