I found metal burr on new oil filter holes, near to cutting edges, as in images attached below. Is this common?
These metal burr is flaking and could easily be scratch off. This scared me off, imaging these get into engine.
This was bought from an official verified vendor website, and i compare/validate few other buyer picture from other official website. They all has these flaking burr and no one seem to realize or comment on this.
These metal burr is flaking and could easily be scratch off. This scared me off, imaging these get into engine.
This was bought from an official verified vendor website, and i compare/validate few other buyer picture from other official website. They all has these flaking burr and no one seem to realize or comment on this.
Last edited by a moderator: