Search results

  1. H

    Valvoline Modern Engine 0w-20 | 2015 GMC Sierra 1500 w/5.3 L83. miles: 47,183 OCI: 11,364

    I'm probably just gonna do it when it hits 0% on the monitor (around 8500mi). This wasn't my intent to run it this long but I'm not dissapointed with the results after viewing a bunch of other L83 UOA results.
  2. H

    Valvoline Modern Engine 0w-20 | 2015 GMC Sierra 1500 w/5.3 L83. miles: 47,183 OCI: 11,364

    I have had this truck since new approaching 5 years. Prior to the switch to Valvoline Modern Engine (VME) Synthetic 0w-20, it had 4 free oil changes it's first couple years under 22000 miles and two paid oil changes all done at the dealer oil change using GM's recommended 0w-20 oil and GM's...
  3. H

    Oil Viscosity Question for LSX Engine with Mods.

    Originally Posted By: fnbrowning There are over 500 needle bearings in the rocker set I thought I would just throw it out there that the OEM LSX rockers use a needle bearing fulcrum while maintaining the sliding friction valve tip end. If anything, these new rockers will stress your oil...
  4. H

    Ford 6.0l diesel oil mix question. Okay to do so?

    Yes, their is a HPOP reservoir and it only holds no more than a quart. On my 7.3, I stick a tube into the external fill port and can suck out 24 ounces. there is a screen at the bottom that prevents sucking out the 8 ounces or less that the screen prevents the tube from reaching.
  5. H

    Mobil 1 and Corvette Question

    Originally Posted By: 440Magnum M1 is excellent oil, ESPECIALLY the 0w40 your 'vette likely calls for. There are numerous other superb choices as well, notably the Shell products (including Pennzoil). What you use is your call, but don't base your decision on advertizing hype. 0w-40 isn't...
  6. H

    GMpartsdirect,com

    Try GMpartshouse.com next time. It is run by a guy named Gene Kelly out of a GM dealer in PA. He is very popular for fast shipping and good prices on OEM parts. I have used him and his service blows Parts Direct out of the water.
  7. H

    fram extended gaurd any good?

    What concerns me is he doesn't truly understand how oil flows through an oil pump. He actually thinks the oil is squeezed through where the gear teeth mesh together.
  8. H

    BMW 335i N54 engine and Auto RX??

    Rotella 5w-40 synthetic will be perfect for you. It is a Group-III oil that will work fine with ARX.
  9. H

    Is A3 the right spec for an old Euro?

    Originally Posted By: Audi Junkie Originally Posted By: Hammer Originally Posted By: Audi Junkie A3 is a synthetic spec. Uh...no, you are not correct. Their is plenty of non-synthetic oil out there rated A3. Such as??? (sold in USA) Castrol GTX 10w-40. PDS Schaeffers non synthetic...
  10. H

    Is A3 the right spec for an old Euro?

    Originally Posted By: Audi Junkie A3 is a synthetic spec. Uh...no, you are not correct. Their is plenty of non-synthetic oil out there rated A3.
  11. H

    The best Diesel engine

    Cummins N14 gets my vote. I have had BAD luck with Cummins ISX.
  12. H

    2011 335i N55 Break-In Oil Change Analysis

    Originally Posted By: SteveSRT8 all single turbo now except the 335is still runs twins. same power, same specs. Not quite...20 more HP and a slight bit more torque for the "IS". That same engine in the Z4 makes 35 more HP. Information is on the BMW website.
  13. H

    Powerstroke oil pressure gauge=vacuum gauge?

    Actually, this has been observed, especially PSD's modified with Twin high pressure Oil pumps. At high throttle, the High pressure oil pump increases demand on oil in the High pressure oil Reservoir. This increased demand shows as a lowering of engine oil pressure as the Low pressure Oil pump is...
  14. H

    Military Avatars

    I used To have a Military Veteran Avatar but apparently it has dissapeared. May I have it back please?
  15. H

    Dex 3 to Pennzoil syncromesh on camaro T-56

    Before i say this...I am NOT an Amsoil fanboy. That being said, I have heard good results with Amsoil's torque drive ATF. It is actually a heavy duty fluid designed for heavy equipment use such as used in Allison transmissions. It has a Dexron3 & Mercon rating but supposedly is minimally...
  16. H

    Select best or favorite HDEO, Rotella T5 or Delo

    Originally Posted By: HangerHarley Originally Posted By: Hammer I prefer Delo over Rotella. My 1.5 million mile Cummins N14 even leaks less oil using Delo. It leaks the most with rotella. My Past UOA results seem to favor Delo too. I figure if 95% use of Delo can make this engine run this many...
  17. H

    Oil for LS1?

    I currently have Pennzoil Platinum in my LS6 and will be using Ultra when I change it. I also, run a K&N oil filter. This car is only used for autocrossing and track days.
  18. H

    Select best or favorite HDEO, Rotella T5 or Delo

    I prefer Delo over Rotella. My 1.5 million mile Cummins N14 even leaks less oil using Delo. It leaks the most with rotella. My Past UOA results seem to favor Delo too. I figure if 95% use of Delo can make this engine run this many miles and still not need an overhaul, it's doing something right.
  19. H

    Pressure washer recommendations

    Correct me if I'm wrong, but I believe the John Deere pressure Washers sold at Lowes are supposed to be good. I believe they have the Honda "GX" motor and good triplex pumps.
Back
Top