Wife's 2013 Equinox is giving me a fit. She's got a warped rotor on the front, so I bought new rotors thinking this shouldn't be too bad. Got the pesky little Torx screw out on both sides with no problem, but the rotors won't budge, even with some persuasion with a 4 lb sledge. I see a $100 brake rotor puller on Amazon, but it says the spread is 12 3/4", and these are 13". Horrible Freight has an assortment of pullers, but I think the disks are still too wide. My 3 armed puller wasn't wide enough. No screw holes in the face to thread some bolts in to pop it off. Doused them in Blaster through the screw holes and degreased the disks so it'd driveable. Even put it back together, drove it around to get the rotors good and hot, but still no go. Any ideas?