Need to replace a leaky seal on my LR3 where the intermediate shaft/CV axle goes into the diff on the passenger side of the front diff of my LR3. The bearing is only $6 so I figure I should replace that too, given it has 160k on it.
So I need a puller...is a blind hole puller like this suited for the job? (I get this is just a link to the collets, but the rental kit at Autozone is just like it)
https://www.summitracing.com/parts/ptm-p...aEaAtfLEALw_wcB
So I need a puller...is a blind hole puller like this suited for the job? (I get this is just a link to the collets, but the rental kit at Autozone is just like it)
https://www.summitracing.com/parts/ptm-p...aEaAtfLEALw_wcB
Last edited: