Hey guys, wondering what tricks you've used in the past to align the gasket with the surface of the block and the pump during install. Mine has to be inserted at an awkward angle, and the bolts can't hold onto it while shimmying it into place. To add insult to injury, the gasket thin metal keeps naturally flexing inward and oufward for an additional challenge. Wondering if there's a food grade or water based low strength adhesive that will temporarily hold it onto the pump surface and then dissolve or disintegrate when the car runs at NOT. I thought about a very thin coat of clear silicone sealant on the outer edges, but that might ruin the gasket coating too. Any ideas would help at this point. Thanks.