Hi again all! Well,finished installing new plenum on the engibe,no leaks. Performance kit,came with new pcv valve,it's housing,spring. It was a pita too get on! The reason...didn't come with a new orange o ring gasket,and thie r was a smaller one,in the pcv valve. I used the old gaskets. The housing didn't wanna close unless the large o ring was out. Use a ratchet, and a sicket, and pressed hard,and turned. I'm assuming,I want supposed too have a o ring gasket thier,correct?
Well,upon starting car no codes. Looked like steam coming out of tailpipe as it warned up the map sensor,sits on top the pcv valve, had come off,in 2 pieces. I put them back together,and installed.the bottom half,was just plastic,and a Tiny Hole In It. So Get A Code...p0401. Something Airflow Inefficient. Did Some GOogling,and the Map SEnsor Comes Up. Could I Just Krazy GLue THe halves OF sensor BAck TOgether? Or Replace IT? When I Took IT out,it already felt FLimsy.
Well,upon starting car no codes. Looked like steam coming out of tailpipe as it warned up the map sensor,sits on top the pcv valve, had come off,in 2 pieces. I put them back together,and installed.the bottom half,was just plastic,and a Tiny Hole In It. So Get A Code...p0401. Something Airflow Inefficient. Did Some GOogling,and the Map SEnsor Comes Up. Could I Just Krazy GLue THe halves OF sensor BAck TOgether? Or Replace IT? When I Took IT out,it already felt FLimsy.
Last edited: