I started using a coping saw for inside moulding, now with the invention of a flap disk! terrific!
The main key to a good caulking job, but a very small angled hole in the caulking tip, smaller than you would think, and then, use little pressure allowing only a small amount to come out. If you do this, you will have almost nothing on your finger and a very small narrow not thick caulk line that will actually seal better because you were able to press down harder.
The main key to a good caulking job, but a very small angled hole in the caulking tip, smaller than you would think, and then, use little pressure allowing only a small amount to come out. If you do this, you will have almost nothing on your finger and a very small narrow not thick caulk line that will actually seal better because you were able to press down harder.