Good evening.
I recently installed a set of Cooper AT3 tires on my Jeep. I have a slight vibration between 45 and 65 mph. They were installed using a Roadforce balancer. I called the shop back, and was told that it's likely one bad tire that's out of round.
So, Discount Tire Direct is sending me a replacement, which I'll bring to the shop. Will they be able to find a tire that's slightly out of round using the Roadforce setup? Could it have been missed by a tech during the original installation who was rushing or just has poor attention to detail? Is there anything I can do to encourage them to get it right?
Thanks friends.
I recently installed a set of Cooper AT3 tires on my Jeep. I have a slight vibration between 45 and 65 mph. They were installed using a Roadforce balancer. I called the shop back, and was told that it's likely one bad tire that's out of round.
So, Discount Tire Direct is sending me a replacement, which I'll bring to the shop. Will they be able to find a tire that's slightly out of round using the Roadforce setup? Could it have been missed by a tech during the original installation who was rushing or just has poor attention to detail? Is there anything I can do to encourage them to get it right?
Thanks friends.