Anybody replaced one? My Malibu needs it and I don't know if I should take it in or do it at home. I am an experienced wrench on trucks but have not done a rack in decades.
I have all the tools, stands, etc.at home.
It"s of course the EPS so no fluid or lines to deal with.It looks pretty easy.
I have already done the intermediate shaft and tie rods but the rack itself is shot. I thought the inner tie rod was bad again because of excess play at the tire but when I removed the inner tie rod boot to check there is a lot of up and down play in the shaft coming out of the rack itself,the tie rods are fine.
I have all the tools, stands, etc.at home.
It"s of course the EPS so no fluid or lines to deal with.It looks pretty easy.
I have already done the intermediate shaft and tie rods but the rack itself is shot. I thought the inner tie rod was bad again because of excess play at the tire but when I removed the inner tie rod boot to check there is a lot of up and down play in the shaft coming out of the rack itself,the tie rods are fine.