Recent content by gus7

add to the mix is the heat like mag drops as in cooking off mag after mag ....a mad minute shooting ....and use of sweet 762 and a few others which have acid in them which is very bad for the barrel !!

i had a new lifter maul itself after replacing a whole set ....i used the white lubaplate and following was red goo ..so who and what is the best lub for break in -it must stick to the parts for the lapping to happen without gulling out ...thxs

one thing is no graphite on weapons ! its NOT good on ar because of the aluminum ! and Teflon is another no/no it breaks down to some very bad stuff ! ar love synthetic oils only !

graphite is BAD news for a lub ...it wear down like a lapping job and ceramics ....[censored] worst than graphite pour in sand !!!

Originally Posted By: partspro Ready Rad is commonly available at many auto-parts stores. Keep you paperwork. While they are not real bad, I replaced the same radiator 3 times under warranty for one of my commercial accounts. I then ordered a fourth, from a second source. They had a different...

Originally Posted By: Tempest Looks way overly complicated. Even more than a FAL. I know a guy that bought one of these and now he wishes that he bought an AR. the 500 design is a AK with a swiss touch ! which comes from the fn-cal design ..great weapon every one i shot less than 1'' moa at 100...

anti's have NO respect to any and all rights aka police state in the works -state eating itself ...as for violence ,a break down of morals and respect of others -a failing state ...

Originally Posted By: oilcoholic I was looking at the install procedure for the bushings on myy wife's vehicle and the Haynes Manual says "Vegetable Oil" that's right,-cooking oil. Also states not to use petroleum or mineral based lubricants. maybe this will help its a'' fake oil name'' Canola ...

the oil is synthetic Penzoil 5w20 was installed i just found out ...does this paint a picture better???any word on this oil good or bad for the TDI ???thxs

The great ping pong game goes on like the fall of Rome ....always prepare for the worst and pray for the lessor to happen!!

For CQB etc its great but some lowers are a bit off ..some fitting maybe needed ...great improvement !

Yes this is my first post here...I worked on foreign and us cars and trucks for 30 years ...Now I seen it all ,a '05 vw jetta TDI with wiped out camshaft lobes and bearings in the copper / cam followers tops gulled out to hydraulic valve open ...I was told first part was done by xxxxxxx did the...