Drill press vise?

[buck91]

How does everybody typically secure their machining vise to their drill press? Obviously there are some channels which are cut for this reason in each, but I'd like something that doesn't require tools to adjust... Working with a new-to-me Ram Machinery table top drill press (approx 8-10in, haven't measured though).

 

[Imp4]

If your drill press has t-slots you can use any drill press vise and some quick clamps.

Carr-Lane or Jergens would be your friend here.

 

[ragtoplvr]

look at this page from grizzly

https://www.grizzly.com/search?q=(t+AND+slot+AND+hold+AND+down+AND+set)+OR+(t+OR+slot+OR+hold+OR+down+OR+set)

they are close to me but others will have that stuff

Rod

 

[Trav]

Something like this may be useful, I am pretty sure I saw a 3" somewhere for smaller tables. It comes in handy for moving the piece to the bit without re-clamping.

https://www.grizzly.com/products/Grizzly-4-Cross-Sliding-Vise/G1064

 

[P10crew]

I use the Heinrich dp vises and fixture locks. Very good clamping force and they last for ever.

 

[Rick505]

Originally Posted by Trav
Something like this may be useful, I am pretty sure I saw a 3" somewhere for smaller tables. It comes in handy for moving the piece to the bit without re-clamping.

https://www.grizzly.com/products/Grizzly-4-Cross-Sliding-Vise/G1064



This one?
https://www.grizzly.com/products/Shop-Fox-3-Cross-Sliding-Vise/D2730