In the past people here have said that rotors don't "warp". That shaking or shuddering during braking is caused by brake pad deposits.
This is on my lathe right now. You can see the spots where the bit is not even touching the rotor. Definitely NOT pad deposits.
The bits are missing the rotor on opposite sides like you would think it would if a rotor was warped.
Thoughts?
This is on my lathe right now. You can see the spots where the bit is not even touching the rotor. Definitely NOT pad deposits.
The bits are missing the rotor on opposite sides like you would think it would if a rotor was warped.
Thoughts?