What is your fetish penetrating oil for very rusted nuts and bolts?
- Thread starter ST2008
- Start date
- Status
Cursing mixed with obscenities.
Not sure if I've noticed a difference using penetrating oil. I almost think anything light and oil like will work. Usually I only spray down once it's broken loose, if the threads are really rusty, then work the nut back and forth so as to work the oil in. Some day I'd like to get a torch and use that approach--seems to work well in all the videos I've seen.
Not sure if I've noticed a difference using penetrating oil. I almost think anything light and oil like will work. Usually I only spray down once it's broken loose, if the threads are really rusty, then work the nut back and forth so as to work the oil in. Some day I'd like to get a torch and use that approach--seems to work well in all the videos I've seen.
PB Blaster. Spray it on then go do something else. Let it work.
I aint go no fetish with penetrating oil especially Deep Creep.
Originally Posted by zorobabel
I usually reach for Wet Platinum
..well, he DID say 'fetish'
Surprised nobody has yet said Astroglide
I usually reach for Wet Platinum
..well, he DID say 'fetish'
Surprised nobody has yet said Astroglide
Kimball-midwest penetrating oil based out of Columbus Ohio its pb blaster without the smell
Wow. On this site
There ain't NOTHING better than MOLAKULES Molasoke.
Find the recipe.
The rest are fine. But the money AINT for the ingredients. It goes into transport advert and packsge
There ain't NOTHING better than MOLAKULES Molasoke.
Find the recipe.
The rest are fine. But the money AINT for the ingredients. It goes into transport advert and packsge
Liquid wrench cause it smells good to me
I have used both, Liquid Wrench and PB Blaster, with equally good results for years.
My preferred lubricant for fetish activities has absolutely nothing to do with nuts and bolts!
PB Blaster just works for me. Good stuff
Dad always has used pb blaster, and we always had good results with it. The shop I'm at now uses Kimball Midwest CB torq(or something like that) and it works well too. We also have an induction heater that works well in the right hands, a set of acetylene torches, and the boss is good at drilling broken bolts.
50/50 acetone and atf. I put it in a pressurized spray bottle and it doesn't evaporate.
- Status
