Channellock Blue Grips

Status
Not open for further replies.
Joined
May 10, 2005
Messages
2,731
Location
Toronto, Canada
They do not stay in place as much as I would like them to. Especially on the needlenose, anytime I squeeze hard, the grips tend to slide a bit down and I am constantly pushing them back into place. Anyone has a fix for this? Epoxy?

Contact cement will not work since the grips have to be slid into place.
 
Lots of suggestions and thank you all for them.

Since we have Gorilla Glue at work I think I will go with it. I plan on roughening up the bare handles a bit on a bench grinder and applying the glue and then sliding the grips on.
 
Status
Not open for further replies.
Back
Top