Usually I use pillow blocks and flange bearings at work on conveyors and for my own equipment just rollers. Both see low speeds and just about no shock load. Keep em wet with any grease and they're good.
I want to use them on a stump grinder. So up to 4,000 rpm, nothing but shock loads and possible dirt. I did get ones with seals, cause I know the basic pillow block bearings are kind of open along the edge.
So I was thinking synthetic molybdenum fortified grease?
I want to use them on a stump grinder. So up to 4,000 rpm, nothing but shock loads and possible dirt. I did get ones with seals, cause I know the basic pillow block bearings are kind of open along the edge.
So I was thinking synthetic molybdenum fortified grease?