Car coasters

007

Messages
724
Location
Clermont, Fl
Thread starter
I am looking to buy some silicone car coaster inserts for the beverage slots in my vehicles. They are as follows: 2017 Toyota Tacoma 2019 Toyota Highlander My question would be if anyone knows the diameter of the cup holders for these vehicles or where I could find that information. Measuring the best I can, my results are as follows. Tacoma - 2.75" Highlander - 3.5" This is measuring old school with a tape measure (at the bottom) as the cup holders appear to taper off from top to bottom and I have nothing to measure with going that far down.. Any ideas or opinions would be much appreciated. Thanks
 
Messages
4,871
Location
NJ
You could make a couple templates out of card board with a compass and scissors to confirm your measurements.
 
Messages
3,649
Location
Worst Case, Ontario
Use a hole saw kit or keep trying cylinders that you can measure externally. A roll of tape is ideal, just get a cheap one from the dollar store. Cutting cardboard while a good idea would be a bit of a pain in the keister, there are plenty of cylinders around the house and they don't have to fit perfectly.
 
Last edited:
Messages
4,871
Location
NJ
Originally Posted by maxdustington
Use a hole saw kit or keep trying cylinders that you can measure externally. A roll of tape is ideal, just get a cheap one from the dollar store. Cutting cardboard while a good idea would be a bit of a pain in the keister, there are plenty of cylinders around the house and they don't have to fit perfectly.
Yeah, that's true. Maybe a can of soup would be perfect. 2.75" seems the standard size they sell on Amazon.
 
Top