Guys, I just bought a new saw and it will be delivered by this weekend. I have read many times that they come very lean from the factory and should be adjusted slightly, especially for break in. I have read three , what look to be educated, posts that go thru the procedure but they differ slightly. Here is a summary of what i read. I wish i could just find the service manual that goes thru the procedure.
1) turn both H/L until bottomed out. Back out 1 turn each as a starting point. Adjust out for richer mixture
2) turn both H/L until bottomed out. Back out 1 1/4 turn each as a starting point. Adjust out for richer mixture
3) turn both H/L until bottomed out. Back out 1 turn each as a starting point. Adjust in for richer mixture
So the real question is this: Do you turn them in our out for a richer mixture?
1) turn both H/L until bottomed out. Back out 1 turn each as a starting point. Adjust out for richer mixture
2) turn both H/L until bottomed out. Back out 1 1/4 turn each as a starting point. Adjust out for richer mixture
3) turn both H/L until bottomed out. Back out 1 turn each as a starting point. Adjust in for richer mixture
So the real question is this: Do you turn them in our out for a richer mixture?