I got a used fender on. I also needed an ac box and blower motor and upper control arm. I did some adjustment on the door closing. I tried a number of things to pull out the rear quarter. I started with hot glue pulling and the sheet metal is just too thick. I used a harbor freight stud gun I got on sale for $109. The studs wont hold and I managed to put a couple of holes in the quarter when they pulled off and took sheet metal with them. I resorted in the end to use an axe to bang it out. I had to cut out a portion of the inner wheel house to get to the back side.
after the axe
I got a hammer and dolly set from summit for $22. I'm going to work this as smooth as I can get it before using body filler. Hopefully I can get it smooth enough with the proper contour so I only need to use spot glaze on it. If not a relatively thin layer of filler should do it.
after the axe
I got a hammer and dolly set from summit for $22. I'm going to work this as smooth as I can get it before using body filler. Hopefully I can get it smooth enough with the proper contour so I only need to use spot glaze on it. If not a relatively thin layer of filler should do it.
Last edited: