Hey guys, I just bought a nice used Toro CCR 2450 (model # 38516, 2005 vintage) off CL for $100. Really nice shape but of course I replaced the paddles, scraper bar, belt, plug, fuel line and fuel filter and cleaned the carb. Wasn't all necessary but I enjoy doing it and I have a like new blower, now.
My question is about the carb. (this blower has the R tek motor with plastic carb).There is a brass jet on the left side under the sticker. I removed the sticker to remove and clean the jet. Now that I've put it back the sticker doesn't adhere anymore over the jet. It appeared like it was sealed almost airtight under the sticker prior to removal. Does it matter if this jet is sealed under the sticker or not? I suppose I could put a small piece of electrical tape over it if necessary.
I haven't seen this question addressed in any of the youtube videos I watched on this carb.
Thanks for the help...and let it snow! (in another 4 months or so..no big hurry)
My question is about the carb. (this blower has the R tek motor with plastic carb).There is a brass jet on the left side under the sticker. I removed the sticker to remove and clean the jet. Now that I've put it back the sticker doesn't adhere anymore over the jet. It appeared like it was sealed almost airtight under the sticker prior to removal. Does it matter if this jet is sealed under the sticker or not? I suppose I could put a small piece of electrical tape over it if necessary.
I haven't seen this question addressed in any of the youtube videos I watched on this carb.
Thanks for the help...and let it snow! (in another 4 months or so..no big hurry)