I need to check my Marine cylinder head for warpage/flatness
I would like to know what y'all use for this procedure?
my father used a piece of glass, but can't remember how he did this.
I would like to use a Machinist straight edge, however there not cheap. I see on the net that some folks are using Steel rulers for this.
thanks for your input
I would like to know what y'all use for this procedure?
my father used a piece of glass, but can't remember how he did this.
I would like to use a Machinist straight edge, however there not cheap. I see on the net that some folks are using Steel rulers for this.
thanks for your input