I did do the drain and fill and measured what came out to put back but that was before I saw the youtube video and found out there is the overflow plug. i do have a good scanner and can measure the trans temp so no problem there. I just hated to dump 200-300 bucks of fluid. As for the Castrol I...
I have a 2016 Nissan Rouge and want to flush the trans fluid. I did a drain and fill last year but finally saw that there is a overfill site hole so I want to do a complete flush with the start and stop method. Does anyone know what amount of quarts I would need to get this done? Also the best...
I have been using this little internet traffic speed program for years. I can not find it anymore online but I saved the .exe to use on all my computers. There is no installing all you do is double click the exe. It reads the speed at your computer (true speed in my opinion) not the speed at...
I have a small craftsman 3 drawer chest I keep full in my truck. But you're taking about at home. I can't say that trying to have a catchall drawer is good. Unless you have only one drawer. 26 inch sounds like you have a standup top and bottom toolbox. I say keep all your tools in separate...
If you are painting a full car in one session then these little guys will not work. You could maybe do a fender at a time then wait 15 minutes for tank to fill. Your paint job would suffer. To paint a full car all at once you need a minimum of a 60 gal tank. Even with a 60 you are just getting...
Originally Posted By: buck91
Has anybody used the coil spring compressor kit from autozone? Not the one for struts. Will be doing a-arms on my '96 GT soon and trying to get the logistics figured out.
I just got done watching this video about that spring compressor.
Front Spring Install on a...
Up until last May I worked at a Firestone and have done hundreds of tires. I think by the 3rd time the owner should have personally done them for you. Yes if you have aluminum wheels the bead area will corrode and we would clean them with the wire wheel. Installation of your new sensors should...