I use Synergyn two cycle in all my air cooled two cycle equipment. I use their water cooled oil in my boat. I like it and how easy everything is to start. Good power. Oh, we are a commercial lawn maintence firm and use a lot of equipment.
This is a real Texas lawn mower!
Note the man: Oil company hat
boots with shorts
beer belly
Note the mower: Steer head on the front
Nitrous Oxide system
Dual exhaust
Just realized there is no way to post a picture. If there is tell me please!
I've had two blades break in half right at the spindle bolt. One half of one blade stuck in the side of my barn about 75 feet away. It really made me think. The two blades broke within one hour of each other. Must have been a bad batch of blades. Different companies use different steel to...
I have a commercial mower with a 25 hp engine and a hydraulic drive, called a ZTR (Zero Turn Radius) I installed temperature gauges on the engine crankcase and the hydraulic reservoir. Then I tried a bunch of different oils to see which gave me the lowest temps. and the best fuel efficiency. I...
There is no rule as to time only condition of the blade. That depends on how much you mow and in what type of conditions. I only get 10 to 15 hours out of a set of blades in our area. The cut will be affected if you sharpen beyond a certain point. Also if it is a multiple blade mower as you...
I switched all my equipment over to Synergyn oil products and the biggest benifit is less fuel consumtion. That means less trips to the gas can. Now if you're looking for a break use a dino and then you can stop and fill up with gas more often, drink a beer, etc. etc..
The main reason I put a pre-luber on was to change the oil. Changing the oil on mowers is the worst part of maintenance I think. I just drive one wheel up on a small ramp and connect my hose via a quick disconnect and flip a switch. Presto, oil's out in under a minute. The best part is the oil...
I have a pre-lube oil system on my 25 hp mower. I pump up the oil presure before cold start and I use it to change the oil every 25 hours. I also installed a remoter oil filter so the filter hangs straight down to facilitate an easier filter change. I quess every one here would think this is a...
I have blown many engines on my commercial lawn equipment so I went on a fact finding mission to find the best lubrication products.
I installed temp. gauges on the engine oil and on the hydraulic oil. I installed oil pressure gauge on the engine. I also installed a pre-lube system to pre-lube...